MXR® Distortion+ Instruction Manual

1. Bubuka

The MXR Distortion+ is a classic guitar effects pedal known for its distinctive distortion sounds. This compact unit is designed to deliver a range of tones from subtle overdrive to classic hard rock distortion. Its germanium-powered, soft-clipped distortion circuit has been a staple on countless recordings, offering a unique sonic character.

Fitur konci:

• Germanium-powered, soft-clipped distortion
• Classic 70s distortion
• Classic early ’80s hard rock tone
• Desain kompak sareng awét

2. Setélan

Before connecting your MXR Distortion+ pedal, ensure your amplifier is turned off. This prevents any potential damage to your equipment.

Sambungan:

1. Sambungkeun gitar anjeun ka INPUT jack di sisi katuhu pedal nganggo kabel instrumen standar 1/4 inci.
2. Nyambungkeun OUTPUT dongkrak di sisi kénca pedal ka anjeun ampinput lifier nganggo kabel instrumen 1/4 inci anu sanés.

Powering pedal:

The MXR Distortion+ can be powered by a 9V battery or an optional 9V DC power adapter (center negative).

• Pamasangan batré: To install a 9V battery, remove the bottom plate of the pedal by unscrewing the four screws. Connect the battery to the clip and place it inside the enclosure before reattaching the bottom plate.
• adaptor kakuatan: Connect a 9V DC power adapter (not included) to the power jack on the side of the pedal.

Gambar: Sisi view of the MXR Distortion+ pedal, highlighting the input, output, and 9V power jacks.

Gambar: handap view of the MXR Distortion+ pedal, showing the four screws that secure the battery compartment.

3. Kadali

The MXR Distortion+ features two primary control knobs and a footswitch for activation.

Gambar: Top view of the MXR Distortion+ pedal, clearly showing the 'Output' and 'Distortion' control knobs.

• OUTPUT: This knob controls the overall output volume of the effect. Turn clockwise to increase volume, counter-clockwise to decrease.
• PANYIMPANGAN: This knob adjusts the amount of distortion applied to your signal. Turn clockwise for more distortion, counter-clockwise for less.
• KUKUH: Toggles the effect on/off. The LED illuminates when the effect is active.

4. Nyuping

The MXR Distortion+ is straightforward to operate, allowing you to quickly dial in a variety of distorted tones.

• Classic Blues Tones: Set the DISTORTION control low (e.g., 9 o'clock to 12 o'clock) and adjust the OUTPUT knob to drive the front end of your amplifier. This will produce a warm, overdriven blues tone.
• Early '80s Hard Rock: Max out the DISTORTION knob (e.g., 3 o'clock to full clockwise) for a powerful, saturated hard rock tone. Adjust OUTPUT to match your desired volume.
• Subtle Boost/Overdrive: For a cleaner boost with a touch of grit, set DISTORTION very low and OUTPUT to unity gain or slightly above.

Demonstration Videos (for related MXR pedals):

5. Spésifikasi

6. Pangropéa

• beberesih: Anggo lawon anu lemes sareng garing pikeun ngabersihkeun pedal. Hindarkeun pembersih atanapi pangleyur anu abrasif.
• Panyimpenan: Simpen pedal di lingkungan anu garing, jauh tina suhu anu ekstrim sareng sinar panonpoé langsung.
• Kahirupan batré: If using a battery, disconnect the input cable when not in use to conserve battery life. Remove the battery if the pedal will not be used for an extended period.

7. Cara ngungkulan

• Henteu aya sora:
  • Pariksa sadaya sambungan kabel (gitar ka input, output ka amp).
  • Ensure the pedal is receiving power (check battery or power adapter).
  • Verify your guitar and ampliifier tiasa dianggo kalayan leres.
• Weak or Distorted Sound (unexpectedly):
  • Replace the 9V battery if it's low.
  • Ensure the power adapter meets the 9V DC (center negative) specification.
  • Adjust the OUTPUT and DISTORTION knobs to find your desired tone.

8. Jaminan & Dukungan

This product is covered by the manufacturer's warranty. For detailed warranty information or technical support, please refer to the official MXR websitus atanapi ngahubungan layanan palanggan maranéhanana langsung. Simpen bukti pameseran anjeun pikeun klaim garansi.