Bubuka
This manual provides comprehensive instructions for the installation, operation, and maintenance of your KEF CI130CR Round In-Ceiling Speaker. Please read this manual thoroughly before installation and use to ensure optimal performance and safety.
The KEF CI130CR is a high-quality architectural loudspeaker designed for in-ceiling installation. It features an Ultra Thin Bezel design, a strong magnetic grille, an asymmetrical tweeter island for wide sound dispersion, a 0.75-inch aluminum dome tweeter with tangerine waveguide, and a 5.25-inch extended response bass driver.
Eusi pakét
- KEF CI130CR In-Ceiling Speaker (Single Unit)
- Grille magnét
- Manual Pitunjuk (dokumén ieu)
- Mounting Template (if applicable, not explicitly mentioned but common)
Émbaran Kasalametan
- Pastikeun kakuatan dipegatkeun tina ampLifier saméméh nyieun sambungan nanaon.
- Consult a qualified electrician or installer if you are unsure about any part of the installation process.
- Ulah ngalaan spiker ka beueus kaleuleuwihan atawa suhu ekstrim.
- Use appropriate safety gear (e.g., eye protection, gloves) during installation.
- Verify the structural integrity of the ceiling before cutting any holes.
Setup sareng Instalasi
1. Ngarencanakeun Penempatan Pamicara
Consider the acoustics of the room and the desired sound coverage. For optimal stereo imaging, speakers should be equidistant from the primary listening position and spaced appropriately apart.
2. Preparing the Ceiling
- Locate ceiling joists to avoid cutting into them. Use a stud finder.
- Using the provided template (if available), mark the cutout area on the ceiling.
- Carefully cut the opening using a drywall saw or similar tool.
3. Kabel
Jalankeun kabel speaker tina anjeun amplifier to the cutout location. Ensure the wire gauge is appropriate for the length of the run. Maintain correct polarity (+ to + and - to -) for all connections.
Gambar: Balik view of the KEF CI130CR speaker. This image illustrates the gold-plated spring-loaded binding posts where speaker wires are connected, as well as the model number and manufacturer information.
- Strip approximately 1/2 inch (12mm) of insulation from the ends of the speaker wires.
- Press down on the spring-loaded binding posts on the back of the speaker.
- Insert the positive (+) wire (typically red or marked) into the red terminal and the negative (-) wire (typically black or unmarked) into the black terminal. Release the posts to secure the wires.
4. Masang Spiker
Gambar: Sisi view of the KEF CI130CR speaker. This image highlights the mounting clamps that secure the speaker to the ceiling.
Gambar: Sisi anu lengkep view of the KEF CI130CR speaker. This view provides a closer look at the internal structure and the robust mounting system.
- Carefully insert the speaker into the cutout hole.
- Tighten the mounting screws (usually located on the front baffle) evenly. This will cause the mounting clamps to pivot outwards and secure the speaker to the ceiling. Do not overtighten.
- Once secured, attach the magnetic grille to the front of the speaker. The grille will snap into place.
Parentah Operasi
Once installed, connect your amplifier to a power source and turn it on. Begin playback at a low volume and gradually increase it to your desired listening level. The KEF CI130CR speakers are designed for wide sound dispersion, providing excellent audio quality across a broad listening area.
Gambar: Hareupeun view of the KEF CI130CR speaker without its magnetic grille. This shows the 0.75-inch aluminum dome tweeter with tangerine waveguide and the 5.25-inch extended response bass driver.
Nyaluyukeun Sora
The CI130CR features an asymmetrical tweeter island. While no direct user adjustments are typically available on the speaker itself, sound characteristics can be fine-tuned through your amplifier's tone controls or room correction systems.
Pangropéa
- beberesih: Dust the speaker grille gently with a soft, dry cloth. For stubborn marks, a slightly damp cloth can be used, but ensure no moisture enters the speaker components. Do not use harsh chemicals or abrasive cleaners.
- Lukisan grille: The magnetic grille is paintable. If you choose to paint it, ensure the paint is applied thinly and evenly to avoid clogging the perforations, which could affect sound quality. Remove the grille from the speaker before painting.
- Pamariksaan: Periodically check the speaker for any signs of damage or loose connections.
Pamérésan masalah
| Masalah | Mungkin Cukang lantaranana | Solusi |
|---|---|---|
| Taya sora tina speaker |
|
|
| Sora menyimpang atawa teu jelas |
|
|
| Speaker grille not staying in place |
|
|
spésifikasi
| Fitur | Rincian |
|---|---|
| Ngaran modél | CI130CR |
| Tipe Speaker | Dina-Ceiling |
| Tipe Pamasangan | Gunung siling |
| Ukuran Speaker | 5.25 Inci (Woofer) |
| Ukuran Tweeter | 0.75 Inches (Aluminum Dome with Tangerine Waveguide) |
| Impedansi | 8 ohm |
| Speaker Maksimum Kaluaran Power | 2 Watts (Note: This value seems unusually low for a speaker. It might refer to a specific test condition or be an error in the source data. Refer to KEF's official documentation for detailed power handling specifications.) |
| Ukuran produk (L x W x H) | 10 x 10 x 5.5 inci |
| Item Beurat | 3.8 pon |
| Warna | Bodas |
| UPC | 637203207471 |
| Produsén | KEF |
Note: Specifications are subject to change without notice. For the most current information, please refer to the official KEF websitus atanapi dokuméntasi produk.
Garansi sareng Rojongan
Kanggo inpormasi garansi sareng dukungan téknis, mangga tingal KEF resmi website or contact KEF customer service directly. Warranty terms and conditions may vary by region and retailer.
Note: The seller of this product has indicated "Sold as is no warranty or returns provided by seller." Any warranty claims or support requests should be directed to the manufacturer, KEF.
KEF Resmi Websitus: https://us.kef.com/
