Defiant 180 Degree Motion Security Light User Manual

Bubuka

Thank you for choosing the Defiant 180 Degree Motion Security Light. This outdoor motion-sensing security light is designed to provide enhanced safety and energy efficiency for your property. It features a wide 180-degree, 70 ft. motion sensor for reliable activation and is Energy Star qualified. This manual provides detailed instructions for installation, operation, maintenance, and troubleshooting to ensure optimal performance and longevity of your security light.

Émbaran Kasalametan

Mangga baca sareng ngartos sadayana petunjuk sateuacan ngamimitian pamasangan. Paranti nuturkeun parentah ieu bisa ngakibatkeun shock listrik, seuneu, atawa bahaya sejenna nu bisa ngabalukarkeun tatu atawa karuksakan harta.

• PERHATOSAN: Résiko shock listrik. Pegatkeun sambungan kakuatan dina sekering atawa circuit breaker saméméh masang atawa ngalayanan.
• PERHATOSAN: Risk of fire. Use only PAR38 incandescent (dimmable outdoor wet rated) or select PAR38 dimmable LED outdoor rated-wet rated bulbs. Do not exceed 120 watts per bulb.
• Taroskeun ka tukang listrik anu mumpuni upami anjeun henteu yakin kana prosés pamasangan.
• Pasang fixture di lokasi anu cocog pikeun panggunaan luar, jauh tina bahan anu gampang kaduruk.
• Pastikeun sadaya sambungan aman sareng insulated leres.
• Operating temperature range: -25°C (-13°F) to +50°C (+120°F).

Eusi pakét

Pariksa yén sadaya komponén aya sateuacan ngamimitian pamasangan:

• Defiant 180 Degree Motion Security Light Fixture
• Pemasangan Hardware (sekrup, mur kawat)
• Instruksi Manual
• Catetan: Bohlam teu kaasup.

Setup sareng Instalasi

1. Pamasangan Fixture

Choose a suitable mounting location on a wall or eave. The motion sensor works best when mounted 6-10 feet above the ground. Ensure the sensor has an unobstructed view wewengkon nu Anjeun hoyong monitor.

Gambar 1: Hareupeun view of the Defiant 180 Degree Motion Security Light, showing the two adjustable light heads and the motion sensor unit below.

1. Pareuman kakuatan dina pemutus sirkuit atanapi kotak sekering.
2. Remove the existing fixture (if any) and disconnect wiring.
3. Gantelkeun bracket ningkatna kana kotak simpang ngagunakeun screws disadiakeun.
4. Pull the electrical wires through the center hole of the mounting bracket.

2. Sambungan Wiring

Make sure power is still off before proceeding with wiring.

1. Nyambungkeun hideung kawat ti fixture kana hideung (panas) kawat ti kotak simpang maké nut kawat.
2. Nyambungkeun bodas kawat ti fixture kana bodas (nétral) kawat ti kotak simpang maké nut kawat.
3. Nyambungkeun hejo or bare copper (ground) wire from the fixture to the taneuh wire from the junction box using a wire nut.
4. Taliti keun sadaya kawat kana kotak simpang.

3. Securing the Fixture and Installing Bulbs

Gambar 2: Samping view of the security light, illustrating the adjustable swivel arms for positioning the light heads and sensor.

1. Sejajarkeun perlengkapan sareng braket pemasangan teras amankeun nganggo sekrup anu disayogikeun.
2. Install two PAR38 bulbs (up to 120 watts each, not included) into the sockets. Ensure bulbs are outdoor wet-rated.
3. Adjust the swivel arms and light heads to direct the light as desired.
4. Adjust the motion sensor's field of vision using its adjustable head.

Gambar 3: Close-up of a light fixture, showing the protective bulb shield and the textured reflector surface.

Parentah Operasi

Once installed, turn on the power at the circuit breaker. The light will enter a warm-up period for approximately 30-60 seconds before becoming fully operational.

Setélan sensor gerak

The motion sensor has adjustable settings, typically located on the bottom or side of the sensor unit.

• Rentang deteksi: Adjust the sensitivity to control the detection distance (up to 70 ft.).
• Setélan waktos: Select how long the light stays on after motion is detected (e.g., 1 minute, 5 minutes, 20 minutes).
• Fitur Dusk-to-Dawn: The light automatically deactivates during daylight hours to conserve energy. It will only activate with motion during nighttime.
• AlertFlash: This feature causes the lights to flash when motion is detected before illuminating to full brightness, providing an additional deterrent.
• DualBrite 2-level lighting: Provides energy-saving accent light at half power and full-power security light when motion is detected. (Note: Some models may not include this feature despite product descriptions.)

Refer to the specific labels on your sensor for exact dial positions and functions.

Pangropéa

Regular maintenance ensures optimal performance and extends the life of your security light.

• beberesih: Periodically wipe the fixture and sensor lens with a soft, damp lawon pikeun miceun kokotor jeung lebu. Ulah make cleaners abrasive atawa pangleyur.
• Ngagantian bohlam:
  1. Pareuman daya dina pemutus sirkuit sateuacan ngaganti bohlam.
  2. Keun umbi tiis sagemblengna sateuacan diubaran.
  3. Unscrew the old bulb and screw in a new PAR38 incandescent (dimmable outdoor wet rated) or select PAR38 dimmable LED outdoor rated-wet rated bulb (up to 120 watts).
  4. The bulb-saver feature extends bulb life up to 4 times the life of standard bulbs.
• Pamariksaan: Annually inspect wiring for any signs of wear or damage.

Pamérésan masalah

If your security light is not functioning as expected, refer to the following common issues and solutions:

spésifikasi

Garansi sareng Rojongan

Defiant products are manufactured to high-quality standards and are warranted to be free from defects in materials and workmanship for a specified period from the date of purchase. For warranty claims or technical support, please refer to the contact information provided on the product packaging or visit the official Defiant websitus.

Punten mertahankeun bukti pameseran anjeun pikeun tujuan garansi.