Fiamma 98655-121

Fiamma F45 Plus End Stop Device User Manual

Modél: 98655-121

Merk: Fiamma

Bubuka

This manual provides essential information for the proper installation, operation, and maintenance of the Fiamma 98655-121 F45 Plus End Stop Device. This component is designed as a replacement part for Fiamma F45 awnings, specifically for models ranging from 2.5 to 3.5 meters in length. Please read this manual thoroughly before attempting any procedures.

Émbaran Kasalametan

  • Always wear appropriate personal protective equipment (PPE) such as gloves and eye protection during installation or maintenance.
  • Ensure the awning is fully retracted and secured before beginning any work on the end stop device.
  • If you are unsure about any step, consult a qualified technician or refer to the complete awning manual.
  • Tetep bagian leutik jauh ti barudak.

Eusi pakét

The package contains one Fiamma 98655-121 F45 Plus End Stop Device. Please verify all components are present and undamaged upon opening the package.

Fiamma 98655-121 F45 Plus End Stop Device

Gambar 1: The Fiamma 98655-121 F45 Plus End Stop Device. This image shows the blue plastic housing, the metal shaft, and the internal spring mechanism.

Setup sareng Instalasi

This section outlines the general steps for replacing or installing the end stop device. Specific procedures may vary slightly depending on your awning model. Refer to your awning's primary instruction manual for detailed installation steps.

  1. Persiapan: Ensure the awning is fully closed and secured. Disconnect any power supply if it's an electric awning.
  2. Aksés: Carefully access the end of the awning where the end stop device is located. This may involve removing an end cap or cover.
  3. Ngaleupaskeun (upami ngaganti): Identify how the existing end stop device is secured (e.g., screws, clips). Carefully remove it, noting its orientation.
  4. Pamasangan: Insert the new Fiamma 98655-121 end stop device into position. Ensure it is correctly aligned and seated.
  5. Aman: Fasten the new device using the appropriate hardware (not included with this part, typically reused from the original installation).
  6. Pasang deui: Replace any covers or end caps that were removed.
  7. Tes: Slowly extend and retract the awning a few times to ensure the new end stop device functions correctly and the awning stops at the appropriate points.

Ngoperasikeun Alat

The Fiamma 98655-121 F45 Plus End Stop Device is a passive component designed to limit the extension and retraction of your Fiamma F45 awning. It works in conjunction with the awning's internal mechanisms to ensure the awning stops at its fully extended and fully retracted positions, preventing over-extension or over-retraction that could damage the awning or its components. No direct user operation is required for this specific device once installed correctly.

Pangropéa

Regular inspection of the end stop device can help ensure the longevity and proper function of your awning.

  • Inspeksi Visual: Periodically inspect the end stop device for any signs of wear, cracks, or damage.
  • beberesih: If necessary, gently clean the device with a soft, damp lawon pikeun miceun kokotor atawa lebu. Hindarkeun ngagunakeun bahan kimia anu kasar atanapi pembersih abrasive.
  • Pariksa fungsi: During awning operation, observe that the awning consistently stops at its intended limits. If it over-extends or over-retracts, the end stop device or other awning components may require attention.

Pamérésan masalah

MasalahMungkin Cukang lantarananaSolusi
Awning over-extends or over-retracts.Damaged or worn end stop device. Incorrect installation.Inspect the end stop device for damage and replace if necessary. Verify correct installation as per the awning's manual.
Device does not fit.Modél anu dipésér salah.Verify the model number (98655-121) against your awning's requirements. This device is for Fiamma F45 Plus awnings 2.5-3.5M.

spésifikasi

AtributRincian
Nomer modél98655-121
merekFiamma
Item Beurat7.4 ons
Dimensi produk4.96 x 2.56 x 2.13 inci (kira-kira 12.6 x 6.5 x 5.4 cm)
KasaluyuanFiamma F45 Plus Awnings (2.5-3.5M)
Tipe AngkatManual (refers to awning operation, not the device itself)
Fiamma 98655-121 F45 Plus End Stop Device with dimensions

Gambar 2: Dimensions of the Fiamma 98655-121 End Stop Device, showing a length of approximately 4.9 inches (12 cm).

Garansi sareng Rojongan

Information regarding the specific warranty for the Fiamma 98655-121 F45 Plus End Stop Device is not provided in this document. Please refer to the original purchase documentation or contact Fiamma customer support for warranty details and technical assistance.

For further support, visit the official Fiamma websitus atanapi ngahubungan departemén layanan palanggan maranéhna. Visit Fiamma Official Websitus

Dokumén Patali - 98655-121

Praview Pituduh Pamasangan sareng Panggunaan Kamar Privasi Fiamma F45
Pitunjuk lengkep pikeun masang sareng nganggo pager tenda Fiamma Privacy Room F45, kalebet daptar suku cadang, léngkah-léngkah perakitan, pangropéa, sareng inpormasi garansi.
Praview Pituduh Pamasangan sareng Panggunaan Kit Lampu LED Fiamma Rafter
Pituduh lengkep pikeun masang sareng nganggo kit lampu LED Fiamma Rafter pikeun kendaraan rékréasi. Ngawengku pitunjuk kaamanan, daptar suku cadang, sareng inpormasi garansi.
Praview Pituduh Pamasangan sareng Panggunaan Fiamma Side W Pro & Side W Pro Shade
Pituduh ieu nyayogikeun pitunjuk pamasangan, panggunaan, sareng pangropéa anu lengkep pikeun asesoris tenda Fiamma's Side W Pro sareng Side W Pro Shade, anu dirancang pikeun ningkatkeun rohangan hirup di luar ruangan.
Praview Pituduh Pamasangan LED Fiamma Rafter sareng Inpormasi Produk
Pituduh pamasangan anu lengkep sareng rinci produk pikeun sistem lampu LED Fiamma Rafter, anu dirancang pikeun kendaraan rékréasi. Ngawengku kaamanan, garansi, sareng spésifikasi téknis.
Praview Pituduh Pamasangan sareng Panggunaan Kit Lampu LED FIAMMA
Pitunjuk pamasangan sareng panggunaan anu lengkep pikeun kit lampu LED FIAMMA, kalebet pedoman kaamanan, spésifikasi téknis, eusi pakét, inpormasi garansi, sareng Déklarasi Kasaluyuan EU.
Praview Pituduh Pamasangan Adaptor Fiamma LMC-TEC pikeun Tenda F65/F80
Pitunjuk pamasangan anu lengkep pikeun adaptor Fiamma LMC-TEC, dirancang pikeun tenda F65 sareng F80. Ngawengku daptar suku cadang, perakitan léngkah-léngkah, tindakan pencegahan kaamanan, sareng inpormasi garansi.