1. Bubuka
1.1 Produk Leuwihview
The Astral Pool Victoria Plus Silent pump, model 65562, is a high-performance, self-priming filtration pump designed for swimming pools. Engineered with thermoplastic materials, this pump offers enhanced durability and protection. Its design focuses on ease of use and maintenance, while operating at a reduced noise level, typically between 61 dBA and 70 dBA. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your pump.
Gambar 1: Sisi view of the Astral Pool Victoria Plus Silent pump.
1.2 Émbaran Kasalametan
Before installing, operating, or performing maintenance on this pump, please read and understand all safety instructions. Failure to follow these instructions could result in serious injury or property damage.
- Kasalametan listrik: Always disconnect power to the pump before servicing. Electrical work should only be performed by a qualified electrician.
- Kasalametan cai: Ensure proper water flow and avoid running the pump dry, as this can cause damage.
- Kasalametan Kimia: Be aware of pool chemicals and their interaction with pump components.
- Barudak: Jauhkeun barudak tina pompa sareng sambungan listrik.
2. Setup jeung Instalasi
2.1 Pump Placement
Position the pump on a solid, level surface, as close to the pool as possible to minimize friction losses in the suction line. Ensure adequate ventilation around the pump for cooling and easy access for maintenance.
2.2 Panyambungan Plumbing
Connect the pump to your pool's filtration system using appropriate plumbing fittings. Ensure all connections are watertight to prevent leaks and maintain prime. Use thread sealant on all threaded connections.
2.3 Sambungan Listrik
This pump operates on 230V single-phase power. All electrical wiring must comply with local codes and regulations and should be performed by a licensed electrician. Ensure the pump is properly grounded and protected by a Ground Fault Circuit Interrupter (GFCI) or Residual Current Device (RCD).
3. Parentah Operasi
3.1 Priming Pompa
Before initial startup or after the pump has been drained, it must be primed. Open the pre-filter lid, fill the basket with water until it overflows, then replace the lid securely. Ensure all valves are open to allow water flow from the pool to the pump.
3.2 Mimitian Pompa
Once primed, turn on the power to the pump. The pump should start drawing water and expel air from the system. If the pump does not prime within a few minutes, turn it off, re-prime, and check for air leaks in the suction line.
3.3 Operasi poean
Operate the pump for a sufficient duration each day to ensure proper filtration of your pool water. The exact duration depends on pool size, bather load, and environmental conditions. Consult your pool professional for recommended run times.
4. Pangropéa
4.1 Cleaning the Pre-Filter Basket
Regularly inspect and clean the pre-filter basket to remove debris. A clogged basket reduces pump efficiency and can lead to damage.
- Pareuman pompa sareng pegatkeun kakuatan.
- Tutup sagala valves diperlukeun pikeun nyegah aliran cai tina kolam renang.
- Unscrew the pre-filter lid.
- Cabut karanjang teras kosongkeun runtah naon waé.
- Bilas karanjang tuntas ku cai.
- Inspect the lid O-ring for damage and lubricate if necessary.
- Replace the basket and secure the lid tightly.
- Pasang deui pompa upami diperyogikeun sateuacan ngamimitian deui.
Gambar 2: Top view showing the pre-filter lid for cleaning access.
4.2 Winterization
In regions subject to freezing temperatures, the pump must be properly winterized to prevent damage. Drain all water from the pump and plumbing lines. Store the pump in a dry, frost-free location if possible, or follow manufacturer guidelines for in-place winterization.
5. Cara ngungkulan
This section addresses common issues you might encounter with your pump. For problems not listed here, or if solutions do not resolve the issue, contact a qualified service technician.
| Masalah | Mungkin Cukang lantaranana | Solusi |
|---|---|---|
| Pompa teu ngamimitian | Teu aya listrik; pemutus sirkuit trip; masalah motor | Check power supply, reset breaker; consult electrician. |
| Pump runs but does not prime or loses prime | Low water level; air leak in suction line; clogged pre-filter; closed valve | Check pool water level; inspect suction line for leaks; clean pre-filter basket; ensure all valves are open. |
| Laju aliran ngurangan | Clogged pre-filter; dirty main filter; restricted plumbing | Clean pre-filter basket; backwash or clean main filter; check plumbing for obstructions. |
| Noise atawa geter kaleuleuwihan | Air leak; cavitation; worn bearings; loose mounting | Check for air leaks; ensure proper water flow; contact service for worn parts; tighten mounting bolts. |
6. Spésifikasi
Technical data for the Astral Pool Victoria Plus Silent 1 CV Single-Phase Filtration Pump, Model 65562:
| Fitur | Spésifikasi |
|---|---|
| merek | Astralpool |
| Nomer modél | 65562 |
| Voltage (V) | 230 |
| Daya (CV) | 1 |
| Capacity (l/h) | 16,000 |
| Nominal Flow Rate (m³/h) | 16 |
| Bahan | Plastic (Thermoplastic) |
| Ukuran Paket | 69 x 40 x 28 cm |
| Item Beurat | 10 kg (22.05 lbs) |
| Sumber Daya | AC Listrik |
7. Garansi jeung Rojongan
Specific warranty details for the Astral Pool 65562 Victoria Plus Silent pump are not provided in this manual. For warranty information, please refer to the documentation included with your purchase or contact Astral Pool directly or your authorized dealer. For technical support or spare parts, please reach out to your supplier or an authorized service center.
