Rockville RV6.3A Car Speaker, RXA-F1 Amplifier, and RWK42 Wiring Kit Instruction Manual

1. Bubuka

This manual provides detailed instructions for the installation, operation, and maintenance of your Rockville RV6.3A Car Speaker, RXA-F1 Amplifier, and RWK42 Wiring Kit bundle. Please read this manual thoroughly before attempting installation or operation to ensure proper function and safety.

Gambar 1.1: Leuwihview of the Rockville RV6.3A Speakers, RXA-F1 Amplifier, and RWK42 Wiring Kit bundle components.

2. Pancegahan Kasalametan

Always observe the following safety guidelines during installation and operation:

• Pegatkeun sambungan terminal batré négatip kandaraan urang sateuacan ngamimitian sagala pagawean listrik.
• Pastikeun sadaya sambungan kabel aman sareng insulated leres pikeun nyegah sirkuit pondok.
• Mount components securely to prevent them from becoming projectiles in case of sudden stops or accidents.
• Avoid routing power cables near sharp edges or moving parts.
• Ulah beroperasi dina amplifier in excessively wet or dusty environments.
• Taroskeun pamasang audio mobil profésional upami anjeun henteu yakin ngeunaan bagian mana waé tina prosés pamasangan.

3. Setup jeung Instalasi

3.1. Unpacking jeung Inspection

Carefully unpack all components and inspect them for any signs of damage. Ensure all items listed in the package contents are present.

3.2. Speaker Installation (RV6.3A)

The RV6.3A speakers are designed for 6.5-inch openings. Ensure the mounting depth of 2.12 inches is compatible with your vehicle's speaker locations.

1. Remove existing speakers from the desired mounting location.
2. Connect the speaker wires to the RV6.3A speaker terminals. Ensure correct polarity (positive to positive, negative to negative).
3. Mount the speakers securely using the provided hardware. The grilles can be installed for protection.

Gambar 3.1: Hareup jeung pungkur views of the Rockville RV6.3A 6.5-inch 3-Way Car Speakers, showing the woofer, tweeter, and terminal connections.

3.3. Amplifier Installation (RXA-F1)

Select a suitable mounting location for the RXA-F1 amplifier, ensuring adequate ventilation and protection from moisture. Common locations include under a seat or in the trunk.

1. Aman dipasang dina ampLifier ka permukaan padet.
2. Power Wiring (RWK42 Kit):
   • Connect the 4-gauge power cable from the RWK42 kit to the amplifier's +12V terminal. Route this cable directly to the vehicle's positive battery terminal, installing the AGU fuse holder within 18 inches of the battery.
   • Connect the 4-gauge ground cable from the RWK42 kit to the amplifier's GND terminal. Securely attach the other end to a clean, unpainted metal surface on the vehicle chassis.
   • Sambungkeun kabel pangaktipkeun jarak jauh ti head unit anjeun ka ampterminal REM liifier.
3. Kabel Speaker: Connect the RV6.3A speakers to the amplifier's speaker output terminals. The RXA-F1 supports 4-ohm stereo or 4-ohm bridged configurations. Refer to the amplifier's terminal block for channel assignments.
4. Masukan Sinyal: Sambungkeun kaluaran RCA unit sirah anjeun ka amplifier's RCA input jacks (CH1/CH2 and CH3/CH4). If your head unit lacks RCA outputs, use the high-level input with the provided harness.

Gambar 3.2: Top view of the Rockville RXA-F1 4-Channel Car Amppangagung.

Figure 3.3: Input and control panel of the Rockville RXA-F1 Amplifier, showing RCA inputs, gain controls, and crossover settings.

Figure 3.4: Power and speaker terminal connections on the Rockville RXA-F1 Amppangagung.

Figure 3.5: Components of the Rockville RWK42 4 Gauge Amp Wiring Installation Kit, including power/ground cables, RCA cables, and fuse holder.

4. Parentah Operasi

4.1. Mimiti Power-Up

After completing all connections, reconnect the vehicle's negative battery terminal. Turn on your head unit. The amplifier should power on, indicated by its status LED.

4.2. Amplifier Settings (RXA-F1)

• Tingkat Input (Gain): Adjust the input level controls (CH1/CH2 and CH3/CH4) to match the output voltage of your head unit. Start with the gain at minimum and slowly increase until the sound is clear and loud without distortion.
• Setélan Crossover:
  • HPF (Saringan High Pass): Use for full-range speakers like the RV6.3A to filter out low bass frequencies that speakers cannot reproduce efficiently. A common setting for 6.5-inch speakers is around 80-100Hz.
  • LPF (Low Pass Filter): Used for subwoofers. Not typically used for the RV6.3A speakers.
  • BPF (Band Pass Filter): Allows a specific range of frequencies to pass.
• Bass EQ: The RXA-F1 features a 12 dB bass EQ. Use this sparingly to enhance bass, avoiding excessive boost that can lead to distortion or speaker damage.
• Modeu Input: Select between 2-CH and 4-CH input mode depending on how many RCA pairs are connected from your head unit.

4.3. Speaker Performance (RV6.3A)

The RV6.3A speakers are designed for clear mid-range and smooth high-frequency reproduction. Proper amplifier settings will optimize their performance. Avoid overdriving the speakers with excessive volume or bass boost, which can cause distortion and damage.

5. Pangropéa

Pangropéa rutin mastikeun umur panjang sareng kinerja optimal sistem audio mobil anjeun.

• beberesih: Paké kaen lemes, garing pikeun ngabersihan amplifier and speaker grilles. Avoid harsh chemicals or abrasive cleaners.
• Sambungan: Pariksa sacara berkala sadaya sambungan kabel pikeun ayana pageuh sareng korosi. Sambungan anu leupas tiasa nyababkeun kinerja anu goréng atanapi karusakan.
• Ventilasi: Pastikeun amplifier's cooling fins are free from obstructions to prevent overheating.

6. Cara ngungkulan

If you experience issues with your system, refer to the following common problems and solutions:

7. Spésifikasi

7.1. RV6.3A 6.5-inch 3-Way Car Speakers

• Peak Power Rating: 750 Watts per Pair / 375 Watts Each
• CEA Compliant RMS Rating: 140 Watts per Pair / 70 Watts Each
• Bahan Woofer: Polipropilén
• Sakuriling: Flex Motion Butyl Rubber
• Tweeter: 1.2-inch PEI dome with ferrite magnet
• Super Tweeter: 0.6 inci
• Tanggapan Frékuénsi: 34-20,000 Hz
• Sensitipitas: 91 dB @ 1w/1m
• Mount Depth: 2.12 inci
• Impedansi: 4 ohm
• Coils sora: Aluminum, 100% oxygen free copper windings
• Magnét: 8 Oz Y25

7.2. RXA-F1 4-Channel Car Amppangagung

• Puncak Kakuatan: 1600 Watt
• Dyno-Certified RMS Power:
  • 4 x 65W @ 4 Ohms
  • 4 x 95W @ 2 Ohms
  • 2 x 200W bridged @ 4 Ohms
• Topologi: Kelas-AB
• Kapasitor: ELNA audiophile grade
• Crossovers: 12 dB/octave variable (HPF, LPF, BPF)
• Bass EQ: 12 dB
• Modeu Input: 2-CH / 4-CH
• Perlindungan: Full IC-controlled

7.3. RWK42 4 Gauge Amp Wiring Installation Kit

• Power/Ground Cable: Premium SuperFlex 4-gauge
• Kabel RCA: Two 17-foot 100% copper twisted-pair
• Panyekel sekering: AGU type with fuses
• Komponén tambahan: Remote wire, speaker wire, loom, installation accessories.

8. Émbaran jaminan

This Rockville product bundle is covered by a Limited Warranty. Please refer to the warranty card included with your purchase or contact Rockville customer support for specific terms and conditions.

9. Rojongan Palanggan

For technical assistance, troubleshooting, or warranty inquiries, please contact Rockville customer support. Contact information can typically be found on the Rockville websitus atanapi dina bungkusan produk Anjeun.