Bubuka
Thank you for choosing the Michelin 12294A Digital Programmable Tire Pressure Gauge. This device is designed for accurate and convenient measurement of tire pressure, ensuring optimal vehicle performance and safety. Please read this manual thoroughly before use.
Eusi pakét
- 1 x Michelin 12294A Digital Programmable Tire Pressure Gauge
- 2 x Lithium-metal batteries (pre-installed or included)
Image: The Michelin 12294A Digital Programmable Tire Pressure Gauge, showing its digital display and control buttons.
Disetél
Pamasangan batré
The device requires 2 Lithium-metal batteries. These are typically included or pre-installed. If replacement is needed:
- Locate the battery compartment cover, usually on the back or side of the unit.
- Buka panutup.
- Selapkeun batréna, mastikeun polaritasna bener (+/-).
- Tutup panutup kompartemen batré aman.
Ngahurungkeun/Pareuman
- Pikeun ngaktipkeun, pencét tombol Tombol daya (often marked with a circle and vertical line symbol).
- The backlit LCD display will illuminate.
- Alat bakal otomatis pareum saatos teu aktip salami waktos pikeun ngahémat umur batré.
Parentah Operasi
Ukur Tekanan Ban
- Ensure the tire is cold for the most accurate reading.
- Cabut tutup klep tina ban.
- Press the nozzle of the gauge firmly onto the tire valve stem. A good seal is crucial for an accurate reading.
- The digital display will show the tire pressure.
- Remove the gauge from the valve stem. The reading will hold on the display for a short period.
- Ganti tutup klep.
Image: The Michelin 12294A gauge being used to measure pressure on a car tire valve.
Ngarobah Unit Ukur
The gauge supports measurements in PSI, KPA, BAR, and kg/cm². To cycle through units, press the Tombol Unit (often the same as the power button or a dedicated button). The current unit will be displayed on the screen.
Programming Tire Pressures
This gauge can be programmed with target front and rear tire pressures for up to two vehicles. Refer to your vehicle's owner's manual or the sticker on the driver's side door jamb for recommended tire pressures.
- With the gauge powered on, press and hold the Tombol program (often an arrow button or a dedicated 'SET' button) until the programming mode is activated.
- Ngagunakeun éta Tombol panah luhur/handap to adjust the target pressure for the front tires of Vehicle 1.
- Pencét éta Tombol program again to switch to the rear tires of Vehicle 1, then adjust.
- Repeat the process for Vehicle 2 if desired.
- The gauge will save the settings automatically after a few seconds of inactivity or by pressing the Program button to exit.
Gambar: A close-up view of the gauge's digital display, showing current pressure and programmable target pressure settings.
Using the Integrated Flashlight
The gauge features an integrated flashlight to assist in locating the tire valve in low-light conditions. To activate the flashlight, press the Tombol senter (refer to device markings, often combined with another function or a dedicated button).
Using the Bleed Valve
If a tire is over-inflated, the built-in bleed valve allows for controlled release of air. While the gauge is attached to the valve stem and displaying pressure, gently press the Bleed Valve button (if present, often a small button near the nozzle) to release air until the desired pressure is reached.
Pangropéa
- beberesih: Lap alat ukur ku lawon anu lemes sareng garing. Ulah nganggo pembersih anu kasar atanapi ngalelepkeun alat kana cai.
- Panyimpenan: Simpen alat ukur di tempat anu tiis sareng garing, jauh tina sinar panonpoé langsung sareng suhu anu ekstrim.
- Ngagantian batré: If the display becomes dim or the device does not power on, replace the batteries. Dispose of old batteries according to local regulations.
Pamérésan masalah
| Masalah | Mungkin Cukang lantaranana | Solusi |
|---|---|---|
| No display/Device does not power on | Batré paéh atawa salah dipasang. | Pariksa polaritasna batré atawa ngaganti accu. |
| Bacaan teu akurat | Poor seal with valve stem; tire not cold; gauge malfunction. | Ensure a firm, airtight seal. Measure when tires are cold. If issues persist, contact support. |
| Air leaks when measuring | Gauge not properly seated on valve stem. | Press the gauge firmly and squarely onto the valve stem. |
spésifikasi
| merek | MICHELIN |
| Nomer modél | 12294A |
| Ngaran modél | Gauge tekanan |
| Beurat produk | 100 g |
| Dimensi produk | 9.3 x 3.3 x 2 cm |
| Batré | 2 Logam litium (kaasup) |
| Unit ukur | PSI, KPA, BAR, kg/cm² |
| Akurasi | +/- 1% |
| Bahan | Metal core, ribbed plastic exterior |
| Tipe Thread | Schrader |
Garansi sareng Rojongan
This Michelin product is manufactured to high-quality standards. For warranty information or technical support, please refer to the documentation included with your purchase or visit the official Michelin automotive accessories websitus. Simpen bukti pameseran anjeun pikeun klaim garansi.





