FERM Air-Cooled Generator PGM1010 User Manual

Bubuka

This manual provides essential instructions for the safe and efficient operation, maintenance, and troubleshooting of your FERM PGM1010 Air-Cooled Generator. Please read this manual thoroughly before operating the generator to ensure proper use and to prevent injury or damage.

Parentah Kasalametan

Always observe the following safety precautions to reduce the risk of injury, electric shock, fire, and property damage.

• Bahaya Karbon Monoksida: Generators produce carbon monoxide, a colorless, odorless, poisonous gas. Operate the generator outdoors in a well-ventilated area, far from windows, doors, and vents. Never operate indoors or in enclosed spaces.
• Bahaya seuneu: Fuel is highly flammable. Refuel in a well-ventilated area with the engine off and cool. Do not smoke or allow open flames near the generator. Store fuel in approved containers.
• Bahaya Setrum Listrik: Do not operate the generator in wet conditions. Ensure all electrical connections are secure and dry. Use only approved extension cords.
• Permukaan Panas: The generator engine and muffler become very hot during operation and remain hot for a period after shutdown. Avoid contact with hot surfaces to prevent burns.
• Barudak jeung Pets: Jauhkeun barudak sareng piaraan tina generator, khususna nalika dioperasikeun.
• Grounding: Ensure the generator is properly grounded according to local electrical codes.
• Perlindungan Overload: Do not overload the generator. The PGM1010 has an overload switch for safe working.

Produk Leuwihview jeung Komponén

Familiarize yourself with the main components of your FERM PGM1010 generator.

Gambar: Hareupeun view of the FERM PGM1010 generator, showing the control panel with the AC outlet, AC protector switch, and engine start/stop switch. The pull-start handle is visible on the right side.

• Tutup Tangki Bahan Bakar: Located on top, for adding fuel.
• Tarik ngamimitian cecekelan: Dipaké pikeun ngamimitian mesin sacara manual.
• Outlet AC: For connecting electrical devices.
• AC Protector Switch (Circuit Breaker): Protects against overload. Resets after tripping.
• Saklar Mesin: Controls engine operation (ON/OFF).
• Mawa cecekelan: Pikeun gampang angkot.
• Shock Absorbing Feet: Reduces vibration during operation.

Setup jeung Persiapan

1. Ngabongkar bungkusan: Kaluarkeun generator tina bungkusna kalawan ati-ati. Pariksa heula bisi aya karusakan nalika dikirim.
2. panempatan: Place the generator on a firm, level surface outdoors in a well-ventilated area, away from combustible materials and at least 1 meter (3 feet) from buildings or other equipment.
3. Bahan bakar:
   • The PGM1010 uses a gasoline and oil mixture (50:1 ratio).
   • Mix unleaded gasoline with 2-stroke engine oil in a separate, approved fuel container.
   • Pastikeun mesin pareum sareng tiis sateuacan ngeusian bengsin.
   • Open the fuel tank cap and carefully pour the fuel mixture into the tank. Do not overfill.
   • Tutup pageuh tutup tangki bahan bakar.
4. Grounding: Connect a grounding wire from the generator's grounding terminal to a suitable ground source, as per local electrical regulations.

Parentah Operasi

Ngamimitian Generator:

1. Ensure all electrical appliances are disconnected from the generator.
2. Setel saklar mesin ka posisi "ON".
3. If the engine is cold, apply choke (refer to specific choke lever location on your unit, usually near the carburetor).
4. Pull the starter handle firmly and smoothly until the engine starts. Do not let the rope snap back.
5. Once the engine starts, gradually push the choke lever back to the "OFF" position as the engine warms up.
6. Allow the generator to run for a few minutes to stabilize before connecting electrical loads.

Nyambungkeun beban listrik:

• Plug your appliances into the AC outlet.
• Do not exceed the rated output of 700 W or the maximum output of 800 W. Overloading will trip the AC protector switch.
• If the AC protector switch trips, disconnect some appliances, then press the "RESET" button on the switch to restore power.

Ngeureunkeun generator:

1. Pegatkeun sambungan sadaya alat listrik tina generator.
2. Keun generator jalan salami sababaraha menit tanpa beban niiskeun heula.
3. Set the engine switch to the "OFF" position.

Pangropéa

Pangropéa rutin mastikeun umur panjang sareng operasi anu tiasa dipercaya tina generator anjeun.

• Busi: Inspect and clean the spark plug regularly. Replace if worn.
• Filter hawa: Clean the air filter element periodically. Replace if damaged.
• Filter bahan bakar: Check and clean the fuel filter as needed.
• Sistim suluh: If storing the generator for an extended period, drain the fuel tank and carburetor to prevent fuel degradation and clogging.
• beberesih umum: Keep the generator clean and free of dirt and debris. Use a dry cloth to wipe down surfaces.
• Panyimpenan: Store the generator in a clean, dry, well-ventilated area, away from direct sunlight and extreme temperatures.

Pamérésan masalah

Upami masalah tetep saatos nyobian solusi ieu, mangga ngahubungi dukungan palanggan.

Spésifikasi teknis

• Jumlah modél: PGM1010
• Tipe: Generator
• Sumber Daya: Bensin
• Kaluaran dipeunteun: 700 W
• Kaluaran maksimum: 800 W
• AC Ayeuna: 3 A
• Mesin: Hawa-tiis, 2-stroke
• BBM: Gasoline and oil mixture (50:1)
• Jilid tank 4.5 liter
• Operating Hours (full tank): Kurang leuwih 8 jam
• Beurat kotor: 17.06 kg
• Beurat barang: 17.1 kg
• Ukuran Paket: 61 x 35 x 1.6 cm
• Fitur husus: Portable, Overload switch, Shock absorbing feet
• Pabrikan: Ferm
• Asal: Cina

Garansi sareng Rojongan

For warranty information, technical support, or service inquiries, please refer to the documentation provided with your purchase or contact your local FERM dealer or customer service center. Keep your purchase receipt as proof of purchase.