PITUDUH GUNA
Programmer Alamat Terminal
| PRG.PAS.MCS |
| 170 x 112 x 35 mm / 270 g |
| Plastic case + mechanical keyboard 0°C … 45°C – IP 31 |
| Catu daya: 9V (batré / batré anu tiasa dicas deui) |
| Sambungan ka terminal via UTP Patch Cable 0.25 cm |
| Alamat sadia pikeun programming: antara "000" jeung "998" Ngetik "999" mungkas program alamat. |
PEDARAN
The PRG.PAS.MCS programmer allows the programming of the address (apartment number) for all types of terminals in the Garis Klasik range: PAS.17A, PAS.27X, PAS.37X, MCS.47X.
This programmer serves as the mobile alternative to the terminal address programming function, enabling the address to be programmed both on-site and in the office, by a single person.
NYAMBUNG KA TERMINAL
- Kabel UTP Patch 0.25 cm
- Balik deui
- Hareupeun
- PRG.PAS.MCS Programmer
- Video terminal – audio (MCS.47X, PAS.27X, PAS.37X)
ON/OFF
- The programmer is turned on by pressing the ON key.
- The programmer turns off:
– 3 seconds after entering the last digit of the programmed address;
– 10 seconds after being turned on, if no key is pressed.
PEMROGRAMAN
Lengkah 1: Connect the programmer to the terminal.
Lengkah 2: Pencét éta ON key on the programmer → The display shows [Alamat pos].
Lengkah 3: On the terminal, press and hold the 
konci.
Lengkah 4: On the programmer, enter the terminal address to be programmed (3 digits required). After entering the last digit, the terminal will issue a confirmation beep, and the key can be released.
07.2025 INS.PRG.PAS.MCS
DIBUAT EU ku:
ELECTRA srl
Parc Industrial Miroslava
Str. Principala 33, 707307, Jud. Ieu - RO
+40 232 214.370
sales@electra.ro
www.electra.ro
ngadukung
ELECTRA Gedong Komunikasi GmbH
Gadnergasse 71, Stockwerk 1, Büro Top 132
1110 Wien – AT
+43 1 810 20 99
sales@electra-automation.at
www.electra-automation.at
Dokumén / Sumberdaya
 |
Electra PAS.17A Terminal Alamat Programmer [pdf] Instruksi Manual PAS.17A, PAS.27X, PAS.37X, MCS.47X, PAS.17A Alamat Terminal Programmer, PAS.17A, Terminal Alamat Programmer, Alamat Programmer, Programmer |