Lambda CS-3000 Runtuyan kurva Tracer
spésifikasi
- Model: Curve Tracer CS-3000 series (CS-3100, CS-3200, CS-3300)
- Collector Supply (HV Mode): Max.Peak voltage – 3 kV, Max. Peak current – 15 A, Max. peak power – 390 W
- Collector Supply (HC Mode): Max.PPeakvoltage – 30 V, Max. peak current – 7.5 A, Pulse width – 50 us to 400 us
- Step Generator: Step rate – 1/10 Step, Pulse width range – 50 us to 400 us
- Pangukuran: Kolektor voltage range – HV: 50 mV/div to 500 V/div, HC: 50 mV/div to 5 V/div
Parentah Pamakéan Produk
Pasokan kolektor
For HV mode, set the max. Peak voltage and current according to the specifications. For HC mode, adjust the settings as needed.
Lengkah Generator
Set the step rate and pulse width within the specified ranges for accurate measurements.
Pangukuran
Paké vol collector luyutage range based on the mode of operation for precise readings.
Ideal for measuring the characteristics of various semiconductors such as IGBTs, MOSFETs, transistors, and diodes etc.
- puncak maksimum voltage 3,000V (high voltage modus)
- Maximum peak current 1,000A (CS-3300 high current mode)
- All models equipped with LEAKAGE mode (1pA cursor resolution)
- USB port to save screen data and setup data
- Equipped with La LAN interface for remote control
Easy-to-understand measurement screen
CS-3000 Series Specifications
Collector supply HV mode
| Modél | CS-3100-300V * 2 | CS-3100 / CS-3200 / CS-3300 | |||
|---|---|---|---|---|---|
| Mode / polaritasna | Full wave rectification/ + – , DC/ + – , LEAKAGE/ + – , AC | ||||
| puncak maksimum voltage | 300V | 30V | 3kV | 300V | 30V |
| Puncak arus maksimum (maximum peak pulse current * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
75mA (150mA * 1 ) |
750mA (1.5A * 1 ) |
7.5A (15A * 1 ) |
| kakuatan puncak maksimum | 120mW / 1.2W / 120W / 390W (Cannot be set when using the maximum peak voltage of 3kV) | ||||
| Horizontal axis range | 50mV～500V/div | ||||
- The maximum instantaneous current value that can be generated (varies depending on the target to be measured and conditions), the measurement should be less than or equal to the maximum peak current value.
Collector supply HC mode
| Modél | CS-3100 / CS-3100-300V * 2 | CS-3200 | CS-3300 | |||
|---|---|---|---|---|---|---|
| Mode / polaritasna | Not equipped with HC mode | Pulse/ + – | ||||
| puncak maksimum voltage | 40V | |||||
| Puncak arus maksimum | 400A | 40A | 1,000A | 400A | 40A | |
| kakuatan puncak maksimum | 4 kW | 400W | 10 kW | 4 kW | 400W | |
| Lebar pulsa | Pulse width is variable at 50µs to 400µs (10µs resolution) | |||||
| Titik pangukuran | The measurement point can be specified (10µs resolution) | |||||
| Vertical axis range | 100mA～50A/div | 100mA～100A/div | ||||
| Alat tés | CS-301 | CS-302 | ||||
Spésifikasi umum
| Loop correction | Hardware | Correction ofthe floating capacitance between the collector supply and the ground | |
| Parangkat lunak | Pseudo-looping through software optimisation | ||
| Generator léngkah | Ngimbangan | Setélan rentang | -10 ～ +10 x STEP AMPLITUDE Setting |
| Resolusi | 1% of the STEP AMPLITUDE setting | ||
| Modeu ayeuna | Rentang | 50nA to 200mA per step, 21 steps, 1-2-5 switching | |
| Arus maksimum | 2A | ||
| Vol maksimumtage | 10V atawa leuwih | ||
| Voltagmodeu e | Rentang | 50mV to 2V per step, 6 steps, 1-2-5 switching | |
| Arus maksimum | 500mA～(～8V), 200mA～(～15V), 10mA～(～40V) | ||
| Vol maksimumtage | ± 40V | ||
| Laju léngkah | 2x 50Hz or 60Hz (1x in AC mode), pulse interval in HC mode | ||
| Lengkah pulsa | Lebar pulsa | 50µs～400µs (10µs step) When in HC mode, the pulse width is 100µs wide before and after the pulse of the collector supply |
|
| Jumlah léngkah | 0～20 Step | ||
| Kaluaran AUX | Rentang | OFF, -40V～+40V (Variable in 100mV steps) | |
| Modeu pangukuran | REPEAT, STOP/SINGLE, SAPU | ||
| sumbu nangtung (full scale 10div) |
Kolektor ayeuna | Rentang | HV mode：1µA/div to 2A/div, 20 steps 1-2-5 switching (HC mode is not included) |
| Akurasi | 2% + 0.05 x VERT/div of readout To this, add the loop correction error for the following maximum peak voltages 0.5µA(30V), 1µA(300V), 6µA(3kV), 12µA(5kV) Specify at least 10% of the maximum peak voltage for 30V, 300V, and 3kV, and at least 30% for 5kV |
||
| Émisi ayeuna (LEAKAGE) |
Rentang | 1nA/div～2mA/div, 20 step 1-2-5 switching (Collector supply mode is LEAKAGE) |
|
| Akurasi | 2% + 0.05 x VERT/div + 1nA or less of readout | ||
| Sumbu horisontal (full scale 10div) |
Kolektor voltage |
Rentang | HC mode：50mV/div to 5V/div, 7 steps 1-2-5 switching (HV mode is not included) |
| Akurasi | 2% + 0.05 x HORIZ/div or less of readout | ||
| Base/ emitor voltage |
Rentang | 50mV/div~5V/div, 7 step 1-2-5 switching | |
| Akurasi | 2% + 0.05 x HORIZ/div or less of readout | ||
| tampilan | tampilan | 8.4-inci TFT LCD | |
| Jumlah titik data | 1,000 points/trace (AC, full wave rectification) 20～1,000 points/trace (SWEEP mode) |
||
| Trace display | Point interpolation display, dot display | ||
| Rata-rata | OFF, 2 to 255 times | ||
| Kegigihan | OFF, SHORT, LONG, Infinite length | ||
| Save internal waveform (REF) | 4 panél | ||
| Kursor | TITIK | Vert, Horiz, β or gm | |
| fLINE | Vert, Horiz, 1/grad, intercept | ||
| GRATIS | Vert, Horiz, β or gm | ||
| JANDELA | Vert, Horiz, β or gm in the WINDOW area | ||
| Data save/read | Mémori | Setup：256 pcs, REF：4 screens | |
| Mémori éksternal | USB1.1：Setup, waveform, screen hardcopy (BMP, TIFF, PNG) | ||
| Jauh | Equipped with a remote 10BASE-T/100BASE-TX 1 port via LAN connection | ||
| Sasayogian tanaga | AC100～240V 50/60Hz, Maximum operating power：500VA (400W), Standby：50VA (7W) | ||
| External dimensions(mm) Beurat |
CS-3100 / CS-3100-300V * 2 | Approx. 424W x 220H x 555D (excluding protrusions and accessories) approx. 28kg (excluding accessories) |
|
| CS-3200, 3300 | Approx. 424W x 354H x 555D (excluding protrusions and accessories) approx. 43kg (excluding accessories) |
||
CS-3100-300V is a made-to-order product.
Asesoris baku
| CS-500 Test adaptor | |
|---|---|
 |
This is a jig for connecting the part to be measured, provided by the customer, and the fixture. (Standard accessories) |
FAQs
Q: Naon anu kudu dipigawé lamun lebar pulsa teuing sempit?
A: If the pulse width is narrow, adjust the settings to widen it within the allowable range to generate the max. peak voltage.
Q: Kumaha calibrate kaluaran suplai collector?
A: The collector supply output can be calibrated by enabling/disabling the output and adjusting the floating capacity as per the instructions provided.
Dokumén / Sumberdaya
 |
Lambda CS-3000 Runtuyan kurva Tracer [pdf] Instruksi Manual CS-3100, CS-3200, CS-3300, CS-3000 Runtuyan Curve Tracer, Curve Tracer, Tracer |